Ender 3S1 Mainboard and Firmware Update

Home Blog Ender-3S1 Series Firmware Upgrade

Ender-3S1 Series Firmware Upgrade

2022-08-31

Please flash this version of the firmware
Format your memory card:
To replace a new (non-gifted) 8GB memory card, please use a Windows computer to format, the steps are as follows
1. Win key + R to pop up a command box;
2. Enter cmd and press Enter;
3. Enter format/q H:/fs:fat32/a:4096 Note (H is the disk name of the memory card, determine the disk number of your memory card, and change it to the corresponding disk number)

How to upgrade the motherboard firmware:
1. Put the STM32F4_UPDATE folder into the root directory of the memory card.
2. Insert the memory card into the machine.
3. Restart the machine and wait for the upgrade to complete (wait 2 minutes).
4. After the refresh is completed, repeat the steps of formatting the card. Do not save the firmware file in the card during normal use.

0 COMMENTS

Tags

Creality 3D Printer Creality 3D

Most People Read

Creality Sonic Pad Klipper Tablet Plug and Play!

In this article, we tested the following features of Creality Sonic Pad

Simplified Klipper operation
Easy Connect to Ender-3 Series
real-time monitoring and time-lapse shooting
10%~30% printing speed up
Input Shaping (Resonance compensation Features)
PID Tuning (calibrate hotbed temperature)

Ender 5 Plus Silent Board: How to Install It

The silent board is a great upgrade for the Ender 5 Plus. The new mainboard is basically the same as the original Ender 5 Plus board TMC2208 Driver. Take the time to read this article before you need to install your new motherboard

Entry-level 3d Printing Troubleshooting - Over/under Extrusion

The extrusion system means so much for 3d printers. A well-calibrated extruder shall block you from many 3d printing issues and imperfections. The just adequate extrusion amount is the goal we calibrate for. But how? Let’s figure that out in this blog.