Recinto de la Impresora 3D: instalación segura, Rápida y Fácil

Easy to build, very very good quality.. i recommand.
Je recommande c'est de très très bonnes qualités : bien épais .. très bien

I bought this enclosure for my Ender 3 Pro, mainly for fire safety.
Let's start by the negative points.

Cons:
- It's very difficult to do maintenance on the printer with this enclosure. There is no opening at all on the left side, which makes it impossible to look at the extruder for example, and I often have to fully remove the printer from its enclosure if I want to make a repair or change a piece.
- There is some noise reduction, but it's limited and should not be one of the main reasons of the purchase.
- The sides are a tight fit and I was forced to remove my filament guide to the left and my tools drawer to the right, even if it was located behind the control panel in a very convenient way.
- The window comes very wrinkled and makes it difficult to look inside.
- No light is included but you will need one to look inside the enclosure if it is closed as it gets very dark.

Now, the pros:
- The stitching feels strong and the velcros feel very strong, which is great to make the enclosure fully hermetic.
- The flame retardant material brings me some peace of mind when I print overnight, coupled with a smoke alarm right above the printer and a fire extinguisher. I still wouldn't leave it fully unattended, since it does say "flame retardant" and not fireproof, but I thankfully haven't had to test that part yet.
- The plug entrance is located to the left, which may be inconvenient for some people, but in my case I think it's a pretty good way to reach the plug quickly to disconnect it in case of emergency.
- It keeps a nice and even temperature when fully closed, I haven't tried printing ABS with it but it's certainly a good way to help the printing.
- The assembly is very easy and the instructions are clear.
- The pocket on the side is very practical, although I wouldn't store a filament spool in there as it's extra flammable material in case of a fire, but it's very convenient to store tools.

This is a nice enclosure but beware some Creality printers are too large for even the “Large” size enclosure.

I bought the enclosure recently for my CR-10. Looks quite quality product. Can be assembled in less than 10 minutes easily. Has a pocket for putting print related stuff. And back hole to get in cables (I keep control unit outside - that is safer, to avoid getting overheat). Installed spooler on top of printer frame inside. (Use metal filament extruder, plastic ones will wear out over time in this setup, or install a metallic washer into the input hole).

Low light is, overpriced. This product should not be priced higher than 20-25 USD I have to use and this will be commercial price. But understanding that, there are not a lot printer enclosures in the market (such as Wham Bam), this is reasonable price.

I bought it for Ender 5 Plus and it fits perfectly. While the bed temperature was 60 degrees Celsius, the internal temperature was measured at 35 degrees Celsius. (Room temperature was 19 degrees Celsius)