Creality3D® Official Store! EU/US/AU/UK/FR/Italy In stock! Get a $5-15 Off at Sign up!

Creality 3d Printer with BL Touch firmware Upgrade Notification

Due to the design of Bl touch motherboard circuit, which results in some printers models like ender 3 pro cannot be used with BL touchV3. So we make some upgrade to ensure that the BL Touch V3 hardware components can be used on the 3d printers such as Ender-3 Pro, CR20 Pro, Ender-5, CR-10, CR-10S, CR-10 S4, CR-10 S5, also a function of the thermal protection function to pop up automatically, optimize the firmware version and improve the customer experience.

CR-10SPRO 1.60.9 Version
Solve the problem below:
  1. When the customer flashes the firmware for the first time and clicks auto home twice, it causes the Z-axis lift up automatically.
  2. The resume printing function is not working very well, which cause a bad user experience.
  3. BLTouch Sensor: https://www.creality3dofficial.com/products/creality-bl-touch

13 comments

  • Roberto Martinez Metzler

    I have updated my Ender 5 with BLTouch V3.1 according to your official video on Youtube, when requesting “Bed Leveling” the head moves from the center to the back, right side, but not to the bottom, then it moves to the left and then again to the left outside the plate about 3 cm where Bltouch cannot touch the plate. I have tried the two firmwares for Ender 5 B84 and B88 and the same thing happens. Please I need help to make it work well. https://www.youtube.com/watch?v=JkTTXtrfJDg

  • Robert Van Meter

    Where can I find instructions to install BLTouch on the CR-10 S5? The BLTouch kit I received is v3.1. Thank you

  • Howard B Spiller

    Does the touch work with the cr10 mini?

  • JENRY HENRIQUEZ

    Hi I have an CR-X machine the original I have bought the BlTouch kit, but I can’t find the firmware for the Board or the Touchscreen so it can support the ABL function.

  • Christian

    Hi Peter,

    have you found a solution for your problem?

Leave a comment