|BL Touch Firmware collection||Download|
BLTouch is a type of semiconductor hall sensor and is an electronic component for 3D printers.
BLTouch is an auto-leveling sensor for 3D Printers that can precisely measure the tilt of Bed surface. It could work with any kinds of bed materials, such as glasses, woods, metals, and so on.
Main functions and controls of BLTouch are the same as usual auto bed leveling sensor, consists of RC servo andmicro switch. Thus, BLTouch can be applied on almost every board.
BLTouch is fulfilled with simple structure and high precision by using progressively designed solenoid and hall sensor. It aims for user convenience and enjoyable printing by adding many smart functions, such as self-test, alarm, alarm release & Touch Switch mode, Blue LED for servo signal indicating and Z-probe(Zmin) Testing.
Self-test : The push pin operate two times in a test when the power is on.
Alarm : The LED light blinks if a problem was found on a self-test or during operation
Wiring defect indicator : Blue and Red LED for indicating wiring defects.
Creality BL Touch HD Photos
Easy to install, does the job, flashed the fireware the arduino way, wouldn't use their weird ISP
Nothing I could do would get the bed properly leveled. I installed the BL Touch Auto Bed Leveling Sensor on my Ender 3 and my prints are instantly better. The first layer is now going down perfectly!
It took about an hour to get it installed. The only issue I ran into was the the "progisp" program needed to update the firmware was bad and I had to find the proper working program on a reddit link. Since then, Creality has fixed the problem and the new current "progisp" program works perfectly!
Added to Ender 3 Pro.
Very straight forward setup, just make sure machine is powered on when flashing firmware.
Making large prints almost entire width of board without adhesion/leveling problems.
Har monteret og installeret på min ender 3
BL Touch Auto Bed Leveling Sensor CR-10/Ender 3/ Ender 3 Pro