BL Touch Firmware
CR-10 V2 BL Touch Firmware1.1.6
About BL Touch
BLTouch is a type of semiconductor hall sensor and is an electronic component for 3D Printers. a precisely measures the tilt of the bed surface. It could work with any kinds of bed materials, such as glasses, woods, metals, and so on.
BLTouch is fulfilled with simple structure and high precision by using progressively designed solenoid and hall sensors. It aims for user convenience and enjoyable printing by adding many smart functions, such as self-test, alarm, alarm release & Touch Switch mode, Blue LED for servo signal indicating, and Z-probe(Zmin) Testing.
The main functions and controls of BLTouch are the same as the usual auto bed leveling sensor, which consists of an RC servo and microswitch. Thus, BLTouch can be applied on almost every board.
Self-test： The push pin operates two times in a test when the power is on.
Alarm：The LED light blinks if a problem was found on a self-test or during operation
Wiring defect indicator：Blue and Red LED for indicating wiring defects.
- Easy to Use: This auto bed leveling sensor makes it easier to level the hotbed, which can precisely measure the tilt of the Bed surface. Bed leveling is not a problem anymore.
- Intelligence self - check and alarm: The function of auto leveling is adopted to make it easier to use and to increase the success rate of shaping.
How to Install Creality BL Touch?
Comparison of BLtouch V1and V2
Thank goodness for the community! One big issue i had with the BLTouch is the Z-Stop signal wires are reversed. Even some of the online documentation had it incorrect. Plenty of online documentation showing the correct orientation. Once i swapped the signal cables around, the bltouch detected and stopped the extruder from going down further. Everything else was pretty straight forward: Installed firmware using ultimaker cura 4.5 thru the USB Port, setting the Z-offset, adding in some additional code to the GCode when slicing. All in all it was a quick install. If anything, i spent WAY more time just OCD'ing with wire management :)
Instructions are better looked up online through youtube but it works great once you can get the z-offset situated! i love not having to manually level anymore!
I have the Silent mainboard v1.1.5.
After install the hardware, upgrade the Silent mainboard FW directly using Octopi, auto bed level, adjust Z offset, enter initial G code and it is good to go.
Easy enough to install. Had some issues flashing firmware because apparently only certain USB ports show up as a COM port and it wouldn't connect my PC to the 3D printer because of it, so that's my bad. Learned that the firmware on the website is out of date so I used TH3D's version which works great. Did a couple test prints and I'm very happy with how well the first layer is laid.
Note: Instructions have some misspellings and the image of progisp shows LowValue and HighValue values swapped vs what they say in text. Go with what the text says to do.
Arrived well packaged. Took a little bit to get it hooked up right, but now it is working great. Had to print a modded case top to move the cooling fan so it would close properly, but again not a big problem..Also had to use a different firmware than the one suggested. But overall happy with the purchase. All the issues only let me get to know my printer better.